Currently have a Greddy Turbo Timer staring at me, but don't have current access to a voltmeter. Anyone know what the five wires are in the ignition connector? Obviously, one is a 12v power source, two are the ignition, ones the accessory power, ones the starter signal since there are 5. For the ignition one, I need the one that doesn't drop voltage when the starter is turned on.

Need to know which one is the 12v, which one is the on, and which one is the acc.


Figured some people might remember if they've installed them before.


If someone has a shop manual or has better luck on HMAService then I do, the name of the connector is "M24".

 

LOL, good timing. I so happen to have a greddy turbo timer "full auto timer' sitting on my desk for my buddy's evo project. I dont' have the manual. One is for power, one for ground, one for switched, one is not used, and the other is for 2 stage hot-at-on.

Do you have the manual? We had to sort out the wires... I could take pictures of it if you need.







hope that helps

 

Manual I got was in Japanese, lol.

Helps in that it shows me what each wire on the Turbo Timer itself are for - still need to figure out which wires to attach that to on the Tib. Think the Ignition Clip has a big blue one, a pink, a gray, a green, and another color.

 

Check out this page my man if this doesnt help let me know http://www.bulldogsecurity.com/.

Go there use their vehicle wiring diagrams and it will lead you right to what you need.

 

I got it installed, wasn't too bad. Just had to play around with a test light for a bit when I took a trip home.