Engine swap wiring troubleshoot
everything seems pinned right even tho I'm getting that steady 5 volts from the signal wire on the crankshaft
Thread Starter
Junior Member
Joined: May 2012
Posts: 28
Likes: 0
From: Canada
Vehicle: 2001 Hyundai Accent
Sorry I meant to say from the sensor!
Anyways, I finally figured out the problem which was a mix of a bad crank sensor and also another wiring issue with my ECU. Re-did some wiring then swapped out the sensor and she runs!! And quite well for the first start up too. Still trying to work out why the rad fan isnt turning on causing overheat. Im guessing bad ect sensor cause the relay switch, fuse and fan motor all check out. Thanks for the help everyone im glad to have this beast going
Anyways, I finally figured out the problem which was a mix of a bad crank sensor and also another wiring issue with my ECU. Re-did some wiring then swapped out the sensor and she runs!! And quite well for the first start up too. Still trying to work out why the rad fan isnt turning on causing overheat. Im guessing bad ect sensor cause the relay switch, fuse and fan motor all check out. Thanks for the help everyone im glad to have this beast going
super happy to hear it's running.
