A'PEXi N1 catback system for Jan. 2001 RD2
Thread Starter
Senior Member
Joined: Dec 2002
Posts: 534
Likes: 0
QUOTE (LordCthulu)
Edit oops lol
I'll take one. I'll send payment whenever your ready.
I'll take one. I'll send payment whenever your ready.
e-check cleared.
I will be sending them out today via UPS Ground.
If you don't get automatic notification from UPS, I'll post later tonight.
Edited:
CARRIER & SERVICE
UPS Ground
TRACKING & REFERENCE
Carrier Trk: 1Z970X220355967119
iShip Trk: MANC74U4Y6QXF
Senior Member
Joined: May 2006
Posts: 4,722
Likes: 0
Vehicle: 2001 Hyundai Tiburon
Yes. Just tell them to make you a bung for the sensor to plop in.
Duh, I knew it doesn't go over the axle... I was inquiring if that was the only difference. Most N1 systems are angled like that to avoid the axle. My custom does this as well, it goes under the axle at like a 60 degree angle but then goes straight into the muffler. A little touch I told them to add, doubt it does too much though.
Some exhausts I've seen drop down below the cars natural path for the exhuast an inch and go straight all the way to the axle and up. Creating only a small 60ish degree bend near the axle and thats it. These cars however are usually on bigger tires and are never lowered to avoid scraping the exhaust itself.
How many bends does it have? Does it follow the stock route to the axle, and is that the only point it changes?
Duh, I knew it doesn't go over the axle... I was inquiring if that was the only difference. Most N1 systems are angled like that to avoid the axle. My custom does this as well, it goes under the axle at like a 60 degree angle but then goes straight into the muffler. A little touch I told them to add, doubt it does too much though.
Some exhausts I've seen drop down below the cars natural path for the exhuast an inch and go straight all the way to the axle and up. Creating only a small 60ish degree bend near the axle and thats it. These cars however are usually on bigger tires and are never lowered to avoid scraping the exhaust itself.
How many bends does it have? Does it follow the stock route to the axle, and is that the only point it changes?
Thread Starter
Senior Member
Joined: Dec 2002
Posts: 534
Likes: 0
arkGreen">A.Gut
LordCthulu
urple">Please send the silencer back to me via priority air mail and PM the charges, so I can credit the postage fee.
I bought those silencer here and didn't know it was 90mm instead of 115mm that I need.
I will replace them once I receive it, since I have to take it to A'PEXi to ask for exchange.
LordCthulu
urple">Please send the silencer back to me via priority air mail and PM the charges, so I can credit the postage fee.
I bought those silencer here and didn't know it was 90mm instead of 115mm that I need.
I will replace them once I receive it, since I have to take it to A'PEXi to ask for exchange.
Thread Starter
Senior Member
Joined: Dec 2002
Posts: 534
Likes: 0
QUOTE (01tibby341)
^ yea i cant wait to get mine
At least, you'll get the right silencer at first time.
All others bought previously are returning their silencer to replace the correct ones. Little hassle for everyone.