gotcha. Thanks a lot man smile.gif

 

Casper,
Both ends of the fuel rail is treaded,so you could configure it the way you want.
You're right,in the pics there's a pipe plug on one end

 

Is there any way you can make the same spacer hold nitrous nozzles. Such as the NX ones.hint hint

 

One more question. Can we get someone with an airram installed to see if this will fit?

 

Redz,
i have the air ram on my car right now ;-)

so for i confirmed the fit with the beta1 & 2 intakes and heads
just need to confirm with the air ram but 99.5% sure it fit quite well

 

Bump

 

sorry i taught i replied to this 02.gif
you mean add nozzles wit the already injectors?
or only use the spacer for the nitrous?
i both case i'm almost sure it can be done,i'll have to confirm with a nozzle to see if we could put them on the underside

 

Hmmm I wonder if the spacer for the injectors could be made out of the same material that is used for phenolic spacers??wink1.gif

 

Yep exactly.


Ditto

 

techcontib, i,ve rechecked,
we could make the spacer a bit different on the bottom side so all the
surfaces are "flat" not angled,we could machine in new holes+ pockets to screw in the nozzle in there

for the phenolic quetion, the first tough was to use this, but,
it wouldn't give a good seal for the injector o ring's du to the laminated composition of the real phenolic stuff
also, it wouldn't have made a "resistant" enough material to screw in the fuel rail mounting lugs
i'd hate it if my fuel rail would pop out of its hole 02.gif