where did you find a piece of aluminum for the idle air bypass?

 

i am just going to weld in a fitting i think... gonna use a -10an i think... not 100% sure, im doing it right now

 

if you had a CAI installed before you can use that elbow with the bypass, assuming it was aluminum, otherwise you could just use the stock one.

 

thats what i thought about doing viper, when i looked on summit thats pretty much all that came up for aluminum pipe.

edit: maybe something like this http://store.summitracing.com/partdetail.a...15&autoview=sku

summit # SUM-220046

double edit: btw, on a quick side note, what the heck does an stand for and how do you measure it??


triple edit!!: air force navy standard
http://www.parker.com/tfd/fittingsol...ANFITTINGS.pdf

and apparently the measurement is in mm??

 

bump

 

i dunno who else's answer your waiting for, im probably the only person who has done this

 

i would just chop a peice off of a crappy ebay intake. its just a straight ~.5 inch pipe.

 

dang, no one has, well I'm planning on going through with the fitting like you. that's all I had come up with as well.

edit: that isn't a half bad idea tibby01, the only reason for not doing that is so i can sell it....

 

alrighty, I found a better solution yesterday. I went to lowes and found that they do sell aluminum pipe. in 1/2" and 3/4". The 3/4" is a perfect match to the idle air bypass on my cai. plus you get like 3ft. for 5 dollars. cool.gif

 

good to know man. thanks for updating.