Cool man, thanks.

 

Ok i took some pics but for some reason i cant enlarge it!!
Anyways as i mentioned above the piping is Aluminum and just noticed that on the Apex I muffler the rear needs to be welded and i took a pic to show..Also want to add that the CAT MIGHT be shot from the looks of it but i never had a problem with the flow as my car was still pulling hard cool.gif
Also it comes with the Flex pipe and all 02 bungs welded in before the cat so it just bolts up to the D/P from my Turbo setup


Here is a pic of the complete system
http://memimage.cardomain.com/member_image....jpg?085409-254

Here is a pic of the ApexI muffler
http://memimage.cardomain.com/member_image....jpg?085409-254

Here is a pic of the rear where needs to be welded
http://memimage.cardomain.com/member_image....jpg?085409-254

Here is all 3 pieces
http://memimage.cardomain.com/member_image....jpg?085409-254

 

Would it be possible to get a few good shots of the combustion chambers when the head is done, just for examples for the DIYer? I'm elbows-deep in there with my grinder and I've only ever seen a couple of Beta heads that have been worked over.

 

tibbytib you still intrested?