01 tib
#1
Member
Thread Starter
Join Date: Sep 2006
Posts: 91
Likes: 0
Received 0 Likes
on
0 Posts
Vehicle: 2001 tiburon
--------------------------------------------------------------------------------
Ok I have decided to sell my 01 tib (i4, beta 2), so if someone wants all the parts that I listed below can take the complete car to. I want $6000 for the entire car with the parts.
• Air ram intake
• Front mount intercooler w/complete set of pipes
• 61mm Throttle Body (w/cruise control)
• 255 walbro fuel pump
• B&G lowering spring (new never installed)
• 4 new struts (new never installed)
• Under drive pulley
• 15 inch evo wheel w/tires
• Engine block
• Adjustable Fuel pressure Gauge
• Head gasket (new)
• Ross Pistons 8.1comp (new never installed)
• Total seal Racing rings (new never installed)
• Crower H beam rods (new never installed)
• Full Standalone computer (XMS new never install/support software/harness/mega spark box)
• Forged Crank Shaft
• Fully built head ported and polished and adjusted cams (everything must go as one for this)
1. Ferrea Valves +1mm over (new)
2. Ferrea dual valve springs (new)
3. Ferrea retainers (new)
4. 268 duration/10.5 lift intake/exhaust cams (new)
5. 2 adjustable cam sprocket (1 for each cam) New
• Spec stg 4 clutch (about 200 miles on it)
• Fidanza Flywheel (about 200 miles on it)
• Phantom Grip (must go with the trans, not taking it apart again)
• Auto meter oil gauge (new never used)
• Auto meter Tach (new Never used)
• 1 racing seat (cant remember the brand)
And all the stock parts interior and exterior must go. I think I have more, I’ll have to check. I want to try to sell the car as one first then may have to part it out
Ok I have decided to sell my 01 tib (i4, beta 2), so if someone wants all the parts that I listed below can take the complete car to. I want $6000 for the entire car with the parts.
• Air ram intake
• Front mount intercooler w/complete set of pipes
• 61mm Throttle Body (w/cruise control)
• 255 walbro fuel pump
• B&G lowering spring (new never installed)
• 4 new struts (new never installed)
• Under drive pulley
• 15 inch evo wheel w/tires
• Engine block
• Adjustable Fuel pressure Gauge
• Head gasket (new)
• Ross Pistons 8.1comp (new never installed)
• Total seal Racing rings (new never installed)
• Crower H beam rods (new never installed)
• Full Standalone computer (XMS new never install/support software/harness/mega spark box)
• Forged Crank Shaft
• Fully built head ported and polished and adjusted cams (everything must go as one for this)
1. Ferrea Valves +1mm over (new)
2. Ferrea dual valve springs (new)
3. Ferrea retainers (new)
4. 268 duration/10.5 lift intake/exhaust cams (new)
5. 2 adjustable cam sprocket (1 for each cam) New
• Spec stg 4 clutch (about 200 miles on it)
• Fidanza Flywheel (about 200 miles on it)
• Phantom Grip (must go with the trans, not taking it apart again)
• Auto meter oil gauge (new never used)
• Auto meter Tach (new Never used)
• 1 racing seat (cant remember the brand)
And all the stock parts interior and exterior must go. I think I have more, I’ll have to check. I want to try to sell the car as one first then may have to part it out