^^^ remember a while back we talked about which way the grain of the metal will go and we both agreed that the grain should go east to west not north and south?

can we get a confirmation on this or are we asking alot?

 

I'll get confirmation for you, I called yesterday but Aaron was gone. I believe he said it runs north to south, because of the size plate they use for it, so we may be stuck there, but for such small pieces, I doubt it'll matter in the end.

 

k, thanks for the great communication Jer. (insert leghumper symbol) lmao.gif

 

Any word on these at all?

 

I dont know who is doing the cad work that needs to be for these but they are slower than hell IMO, i don't care who it is. I could have had these done ten times over by now, no joke.

I was just thinking about these today at work Ericy and was almost to the point of calling some junkyard in canada, paying alot of money for a whole instrument cluster, just for the center ring.

 

jer has the kph bezels that i used to do the initial CAD drawings.

 

^^^I am pretty sure he sent them to speedhut and supposedly there were going to CAD them on their "spare time".

I am pretty sure we have had enough spare time since then,lol.

 

I haven't called them in some time.

Text me later today and I'll hit Aaron up, they should be able to knock them out now.

 

(05:23 PM) RED ZMAN - Feeel free to paste this into the thread.

(05:22 PM) RED ZMAN - He's checking the cad drawing i sent him and going to order up the MPH ones today, he's got to draw the KPH ones though, but shouldn't be long. He promised to stay in touch with me, they've been busy too with the whole SEMA thing and all of that.

(05:22 PM) RED ZMAN - Just got ooff the phone with Aaron with speedhut.

 

Any Word on these?