Anyone know where the clock wires into? Got a black female end and have no idea where it goes, from hooking up subs, noticed black wire w/ female end, and when hooked pwr back up clock ceased to turn on. Help???

 

Please post in the correct forum (this one should have gone to Interior) and use proper thread titles.

Not really understanding your question either really, it's just a plug and the only one like it, you can't plug it anywhere else by mistake..

 

Moving this to proper section. This area is for DIY writeups only please. Welcome to the site.

 

I don't really understand how you did that. That clock is above the heater cluster. If you only pulled one wire and you were able to put it back in, it should work, unless you blew a fuse.

Anyways, here's the schematic.

 

What are you trying to do in the first place?

 

Thx for the help got it taken care off.

 

...

Again, please read the site rules and FOLLOW THEM for all sections. use a MEANINGFUL title to your posts, and let everyone know what you did, as it could help someone else.

Lastly, take the extra .025 seconds to TYPE your words out, stuff like Thx and pwr take an extra second at MOST to type fully. It's in the rules. Your thread has put up more questions than it answered.