Removing Panel Around The Steering Wheel
Senior Member
Joined: Jul 2001
Posts: 7,063
Likes: 0
From: Clovis, NM
Vehicle: 2010 Jeep Wrangler Unlimited
The steering wheel trim has either two or three screws going up through the bottom. The knee panel requires you to remove the shifter surround and radio surround, then pull the screws from the knee panel and it should be loose. There is one screw behind the dimmer switch as well. After that you need to undo the two screws holding the hood release and the two holding the OBD port.
Senior Member
Joined: Mar 2002
Posts: 34,642
Likes: 0
From: Los Lunas, New Mexico, USA.
Vehicle: 2001 Hyundai Tiburon, 2004 Kia Sorento, 2010 Kia Soul
You could look in the DIY section and see picture by picture writeups on how to get all of this apart in the gauge face DIY.
Senior Member
Joined: Mar 2002
Posts: 34,642
Likes: 0
From: Los Lunas, New Mexico, USA.
Vehicle: 2001 Hyundai Tiburon, 2004 Kia Sorento, 2010 Kia Soul
QUOTE (prits_uk2002 @ Mar 27 2007, 04:38 AM)
is there any guide which tells me how to strip the entire interea
You are kidding me right? I told you, RIGHT ABOVE YOUR POST, where to go and get a picture by picture DIY for taking the entire dash apart.
READ, and go find it.
