How connect Accent Temp Guage to Beta Engine
#1
Senior Member
Thread Starter
Join Date: Dec 2011
Location: England
Posts: 539
Likes: 0
Received 0 Likes
on
0 Posts
Vehicle: Hyundai Accent
How connect Accent Temp Guage to Beta Engine
Attachment 945
fixed.
Remove cluster. Far Right connector plug (Behide Fuel guage)
Connect Blue Wire to the Single Connector Temp Sender on beta engine. (Duel sensor is for ECU)
fixed.
Remove cluster. Far Right connector plug (Behide Fuel guage)
Connect Blue Wire to the Single Connector Temp Sender on beta engine. (Duel sensor is for ECU)
#2
Senior Member
Thread Starter
Join Date: Dec 2011
Location: England
Posts: 539
Likes: 0
Received 0 Likes
on
0 Posts
Vehicle: Hyundai Accent
Am i right in thinking i should wire it diectly to the cluster. ?
On Rear..
Ground.
12V.
Sensor.
Ground and 12V are fine. So wire sensor directly to Sensor Wire.
On Rear..
Ground.
12V.
Sensor.
Ground and 12V are fine. So wire sensor directly to Sensor Wire.
#4
Super Moderator
The voices tell me you need the wiring to the computer also. There is at least one temperature sensor in the fuel control system. Wiring the gauge is all well & good but if you get bad fuel trim what's the point?
#6
Senior Member
Thread Starter
Join Date: Dec 2011
Location: England
Posts: 539
Likes: 0
Received 0 Likes
on
0 Posts
Vehicle: Hyundai Accent
Iv since removed the stock ecu.
Is there anyways i can do to bypass this problem. I use a Megasquirt 2 V3.0 ECU for my beta swap.
on all my wiring diagrams i don't have a temperature gauge Pin out.
Is there anyways i can do to bypass this problem. I use a Megasquirt 2 V3.0 ECU for my beta swap.
on all my wiring diagrams i don't have a temperature gauge Pin out.
#7
Senior Member
Thread Starter
Join Date: Dec 2011
Location: England
Posts: 539
Likes: 0
Received 0 Likes
on
0 Posts
Vehicle: Hyundai Accent
For beta wiring
The Hyundai service website will not show me any images for my accent
Will they hyundai Guage cluster be 12 Volts.. Because if ecu powers the Temperature gauge i will need to by pass it now.
The Hyundai service website will not show me any images for my accent
Will they hyundai Guage cluster be 12 Volts.. Because if ecu powers the Temperature gauge i will need to by pass it now.
#8
Senior Member
Join Date: Mar 2008
Location: Canada
Posts: 1,682
Likes: 0
Received 0 Likes
on
0 Posts
Vehicle: 1991 Impulse RS
why not just run an separate universal temp gauge if that is your problem?
http://www.ebay.com/itm/universal-2-...2c0783&vxp=mtr
http://www.ebay.com/itm/universal-2-...2c0783&vxp=mtr
#9
Senior Member
Thread Starter
Join Date: Dec 2011
Location: England
Posts: 539
Likes: 0
Received 0 Likes
on
0 Posts
Vehicle: Hyundai Accent
why not just run an separate universal temp gauge if that is your problem?
http://www.ebay.com/itm/universal-2-...2c0783&vxp=mtr
http://www.ebay.com/itm/universal-2-...2c0783&vxp=mtr
It would annoy me seeing the gauge doing northing..