check this out

http://hackaday.com/2011/01/06/drill...kinect-camera/



I'd like to try this:

http://hackaday.com/2010/11/15/rende...-kinect-video/



Here's a good way to make parts (small scale though)

http://www.interactivefabrication.co...cate-yourself/





it's possible to do just about anything with the kinnect. May be a good thing to look at if you're serious about 3d modeling.

 

Again, big thanx for the input guys! ChattTownShark, I see what you mean, that'll be a tough one to address considered how that corner is made but i'll play a bit

@TibbyTurbo: Trust me, I have pondered his but it take a hell of a lot of precision to pull that off. I did design the crank I'm using in the 944 but the process was tedious at hell. I guess it also depends on the part, but I'm no where near ready to do something hardcore on the tibs. Though that would be a fun project one day