Im working on the Ford 4.6l thottle body install on my Beta, I have the mechanical side of it figured out and it is in the works but im pretty much clueless about the wiring. I plan on making an adapter plug to allow the ford TB to plug into my stock wiring harness without splicing into it, I can get the plug, i just dont know which wire goes to which. Can someone who has done this tell me what they did? If not can someone shoot me a link on how to figure it out myself, I have a multimeter and I can use it, I just dont know what im looking for. This will run without a CEL.... right?

 

I will post the pins later today for you.

 

you mean with the tps right?

and yes, you should not get a cel. it will basically act the same. the computer will never even know its there

 

hey do you talk to spikie (Jerzy) that often? He did this mod recently himself, i think his install went smoothly, you should ask him if you can get a hold of him.

 

once you get this done you should do a DIY with partnumbers and pics. i could find that TB at the yard pretty easy. will that mod still accomadate cruise?

 

swap over the pulley and it will. im looking for a tps for one of these if anyone knows where one is

 

Here is a quick drawing that I did for this, if you have any questions please ask.



And here is an example of the 70mm Mustang TB I have on my car.

Link

 

thanks tim, I kinda assumed it would be you who would have firgured it out. I asked Jerzy and he said he could not remember. Tim, did your throttle body have a little 3/16" hole drilled in the butterfly? if so will the car idle properly on it? without the idle controler I mean. Tim, would you consider selling a flange for the ford throttle body by itself? Thanks guys