M3 esque mirrors:
#1
Guest
Posts: n/a
Found this on a korean site pretty cool smile.gif
1st get a st of side markers:
(don't mind the korean) smile.gif
Tools/supplies:
Side markers
File
extra 12 guage wire red and black
wire crimpers, and splice connectors
Drill and drill bits
screw driver to take off door panel:
2nd: Get a pice of thin plastic sheet and make a pattern of the side marker to scale and trace the outline onto the mirror:
(Notice plastic pattern)
3rd: take a drill bit not too big and make holes inside the pattern, until it is all the way around the drawn out lines of the pattern.
4th: Should look a little like this:
5th: Take a file and file the rough chunks smooth till it is even around
6th: Insert Side markers into lamps:
make sure it is a snug fit, if not use silicone to seal it:
Then run the wires in through the triangle door piece into the inner part of the door:
You will need to extend the wires with wire and run them inside the door by the hinge into the engine bay, till you find the TURN signal wires, and tap into the + and the -.
1st get a st of side markers:
(don't mind the korean) smile.gif
Tools/supplies:
Side markers
File
extra 12 guage wire red and black
wire crimpers, and splice connectors
Drill and drill bits
screw driver to take off door panel:
2nd: Get a pice of thin plastic sheet and make a pattern of the side marker to scale and trace the outline onto the mirror:
(Notice plastic pattern)
3rd: take a drill bit not too big and make holes inside the pattern, until it is all the way around the drawn out lines of the pattern.
4th: Should look a little like this:
5th: Take a file and file the rough chunks smooth till it is even around
6th: Insert Side markers into lamps:
make sure it is a snug fit, if not use silicone to seal it:
Then run the wires in through the triangle door piece into the inner part of the door:
You will need to extend the wires with wire and run them inside the door by the hinge into the engine bay, till you find the TURN signal wires, and tap into the + and the -.