so today i got my new rims in today but i totally forgot about these F&%&* captive rotars and they wont fit right.
--would these wheel spacers be a good temporaily fix till i do a non captive swap

Wheel Spacers

which one should i go with the 25mm or 15mm

Thanks in advance
Matt

 

Well, you do not need 15mm spacers. You can either bore out the back of your rims to make room for captive setup or you can go with 8mm spacers.

The heads of the bolts only come out 7mm. Also if you get wheel spacers, make sure to get hub centric wheel spacers.

 

if i have someone bore out the back will it hurt the strengh of the rims ?

 

It depends on the rims you have. In most cases no, unless its really thin. All you would need to bore out 4 holes 7 mm's

 

ok thanks, how about the one that is on the rear disk, it just have 1 screw i would prolly need to bore that part too, and sry about this i really dont know much about the wheels except how to change them

 

In the rear you have non captive setup so you should be fine. I'm not talking about the BIG hub bolt when I mean boring out your rims. It's the little ones I'm referring too.

 

i c what u are sayin, i would never attempt this myself i will have to take it to some wheel shop or something

 

i dont see those spacers fitting with the captive bolts. those fuggers are a lot bigger than those little oddly drilled holes in the spacers.

 

http://www.rdtiburon.com/index.php?showtopic=14232

wink1.gif

 

Sparticus i would take u up on those if i had the funds, but i spent all my money on the rims so i am kinda broke with a set of rims sittin at the house collectin dust

but thanks 4 the offer