WTB: Valve Cover
#1
Senior Member
Thread Starter
Join Date: Mar 2006
Location: Ashland, KY
Posts: 4,244
Likes: 0
Received 0 Likes
on
0 Posts
Vehicle: 2001/Hyundai/Tiburon
WTB: Valve Cover
Anybody got one?
beta 1
needs to be in pretty good shape. Got one from ebay that was super brittle and cracked while drilling, the gasket was actually snapping in two as I took it off. I'm tapping it for vent.
beta 1
needs to be in pretty good shape. Got one from ebay that was super brittle and cracked while drilling, the gasket was actually snapping in two as I took it off. I'm tapping it for vent.
#4
Senior Member
Join Date: Nov 2007
Location: Albany,NY
Posts: 1,139
Likes: 0
Received 0 Likes
on
0 Posts
Vehicle: 2011 Tuscon
I got one at my parents house, no cracks, does have 80k on it though. Even have a gasket set i could throw in to if you wanted. I just needed a spark plug tunnel seal but i had to get the whole kit
#5
Senior Member
Thread Starter
Join Date: Mar 2006
Location: Ashland, KY
Posts: 4,244
Likes: 0
Received 0 Likes
on
0 Posts
Vehicle: 2001/Hyundai/Tiburon
That's cool, when do you think you could ship it by. The sooner the better since I'm trying to get it done asap. I'm going to check the local salvage yards today. They usually don't have anything though.
#6
Senior Member
Join Date: Nov 2007
Location: Albany,NY
Posts: 1,139
Likes: 0
Received 0 Likes
on
0 Posts
Vehicle: 2011 Tuscon
I'm planning on going up there tomorrow, so if all is well with the cover, which im sure it is, then i can ship monday.
Only problem is the gasket set is in my tool box at work, so if you want the gaskets too i can't ship it out till wed.
Just let me know, we'll make it work
Regarding the drilling, just heat the area with a hair dryer for a minute to soften the plastic before you start drilling, should make it less prone to cracking
Only problem is the gasket set is in my tool box at work, so if you want the gaskets too i can't ship it out till wed.
Just let me know, we'll make it work
Regarding the drilling, just heat the area with a hair dryer for a minute to soften the plastic before you start drilling, should make it less prone to cracking
#7
Senior Member
Thread Starter
Join Date: Mar 2006
Location: Ashland, KY
Posts: 4,244
Likes: 0
Received 0 Likes
on
0 Posts
Vehicle: 2001/Hyundai/Tiburon
Hey! Found another valve cover...im my garage. Its covered in paint from where the junkyard wrote on it so I'll be be interested in yours. Let know what you find. Shipping to a business address 41101.