Small Tiburon Emblem In Aluminum
#1
Senior Member
Thread Starter
Join Date: Aug 2009
Location: Washington D.C.
Posts: 11,992
Likes: 0
Received 0 Likes
on
0 Posts
Vehicle: Hyundai Tiburon FX
I've spent 40 hours fiberglassing a frame in my center din and want to give it the finishing touch shortly after it's painted.
here is dtn's turbulence logo. i want mine to have the tiburon logo in brushed aluminum as thin as possible perhaps so thin it can snap. is it possible for you to make a small one? about 1.5cm in height?
here is mine:
i would like to have it up top where the flat part is. the smaller the more factory it will look.
thanks.
here is dtn's turbulence logo. i want mine to have the tiburon logo in brushed aluminum as thin as possible perhaps so thin it can snap. is it possible for you to make a small one? about 1.5cm in height?
here is mine:
i would like to have it up top where the flat part is. the smaller the more factory it will look.
thanks.
#3
Moderator
Same here! I'd like to get the billet aluminum turbulence emblem with the correct graphic and all. Does your machine do aluminum?
#7
http://www.hyundaiaftermarket.org/images/vendor1.png
Join Date: Mar 2008
Posts: 224
Likes: 0
Received 0 Likes
on
0 Posts
Vehicle: 2003 Hyundai Tiburon
QUOTE (UnHolyTib @ May 20 2007, 07:49 AM)
My equipment does not do metal - I can make those out of stainless looking material....
Uh could you respond to my PM on NT? I've sent it twice now...
/hijack
looks like that will look hot man!