oil pump drive gear
11-19-2011, 11:00 PM
#3
Administrator
Join Date: Mar 2006
Location: Lacey, WA
Posts: 12,515
Likes: 0
Received 2 Likes
on
2 Posts
Vehicle: Two Accents, Mini, Miata, Van, Outback, and a ZX-6
The gear behind the crank pulley that drives the timing belt? I don't think you need a puller. Should just slip off.
11-20-2011, 07:58 AM
#4
Senior Member
Thread Starter
Join Date: Jan 2011
Location: Mass
Posts: 190
Likes: 0
Received 0 Likes
on
0 Posts
Vehicle: 1998 Elantra
ya mine is on there real good lol, im gunna try some 3 jaw or 2 jaw pullers i have layin around the garage but im not shure if there small enough
11-20-2011, 08:58 AM
#5
Super Moderator
Soak it with a heat gun or hair dryer until it's almost too hot to handle and try pulling the gear again, before spending deposit dollars on a puller.
11-22-2011, 05:37 AM
#6
Senior Member
Thread Starter
Join Date: Jan 2011
Location: Mass
Posts: 190
Likes: 0
Received 0 Likes
on
0 Posts
Vehicle: 1998 Elantra
i made a custom puller out off junk pullers i had laying around the garage, a 2 jaw slim grip kinda deal, there wasnt alot of room behind the gear to fit a puller thats why i had to find something with small jaws, well its off, now im removing all the freeze plugs (; all of em ar out except on little muther that got stuck in, but i got my ways lol