OK guys im going to Finish the part out of this wonderful green tibby,The car was wrecked on the front passenger side

There is still lots of parts left on this car:

-lots of interior parts (DASH, dash pieces, seats, headliner, hatch trim, etc.)

-engine (block, heads, intake manifold, water pump, tranny, drive shafts, etc.)

-suspension (factory struts & springs, suspension arms, sway bars, calipers, etc.)

i still have all the seats and a majority of the interior parts. The hatch is still on, along with all the doors. The suspension is all intact with the exception of the passenger rear suspension arms and trailing arms. I will be pulling the motor and tranny out next weekend im sure brain01tib will still has DIBS. Also i will me pulling off parts than junking the shell so guys let me know what part(s) you may need . i will be checking the e-mails and pm's everyday


Okay here's the list

Beta motor with 58k $300
Entire whole auto to 5 speed swap $500

Beta stock oil cap $10 shipped

1st/2nd gen gas cap $15 shipped-Green

1st gen hatch lifts $20 shipped

1st/2nd gen drivers FRT calipers $50 shipped

1st/2nd gen glove box door $20 shipped

1st/2nd gen inside door sills (plastic pieces) $20 shipped for both sides

1st/2nd gen stock jack $20 shipped

1st/2nd gen hood hinges $15 shipped

1st/2nd gen interior rear window plastic trim surround $20 shipped for 1 side, $30 shipped for both sides
shipped for 1 side, $35 for both

1st gen brake master cylinder $40 shipped

1st gen headlight switch unit $15 shipped

1st gen drivers side door glass $25

1st/2nd gen stock ebrake handle, $10 shipped

1st/2nd gen dome light $20 shipped

1st/2nd gen headliner $50 shipped

RD1 front tweeter speaker grilles $15 shipped

RD1 rear speaker grille $15 shipped

RD1 Clock (unpainted) $25 shipped

RD1 rear defroster switch (entire unit unpainted) $15 shipped

1st gen upper and lower plastic dash pieces unpainted $50 shipped







Lots of other pics of other RD1 stuff Parts that need to sell !!!!!

 

Do you know if the RD 1 uses the same ashtray assembly as the RD2?

How about the door panel for the drivers side? I could REALLY use the center curved plastic section.

 

Are the seats cloth?

 

If you aer willing to box up and ship a large interior piece to Prescott, AZ I could take the two door panels off your hands. I also need JUST the driver side window controls included. Pass not needed. wink1.gif

If you have the parts PM me your offer and I will send money asap.

 

How about your cupholder. Mines broken. When i push mine to pop it out, it goes inside and falls off, instead of coming back out. sad.gif

 

^^are four screws tightened onto the radio surround?

 

Id like to get one of your headlights please.

 

i got dibs on the lid thing on the center counsole (if its black)

Its the thing between the passenger and drivers seat that opens and closes...

All i need is the lid.
Its two screws and a little hook thing (screws and hook not needed)

Ill pay ASAP

 

driver side mud flap thing if its the same for the rd2. ill take a pic of what im talking bout when i get home. also, the interior screw covers if you have them. Top plastic piece of the steering wheel column. driver side door panel, jsut plastic piece (that you would paint) if patreezy doesnt take it. thanks

 

I also have dibs on the axels and manual shifting parts like the cabels and all. (just making sure no one else takes them)