LC2 Accent Performance Turbo Head
Thread Starter
http://www.hyundaiaftermarket.org/images/vendor1.png
Joined: Jul 2008
Posts: 211
Likes: 0
From: Brisbane, Australia
Vehicle: 2003 Hyundai Accent 22PSI Boost
LC2 Accent Performance Turbo Head
howdy howdy,
alrighty...
Up for grabs I have my fully worked head to fit a G4ED Accent or possibly a G4EC.
Modifications:
Uprated valve springs (65lb to work on stock cams)
Fully ported and polished
Recently decked
Stainless Steel O-Ring wire inserts
New guides
Hardend seats
CC matched combustion chambers
Head was rebuilt 10000kms ago.
Will supply a new Copper head gasket/Deco plate and sealer.
$1000 ONO
Cheers Ryan
alrighty...
Up for grabs I have my fully worked head to fit a G4ED Accent or possibly a G4EC.
Modifications:
Uprated valve springs (65lb to work on stock cams)
Fully ported and polished
Recently decked
Stainless Steel O-Ring wire inserts
New guides
Hardend seats
CC matched combustion chambers
Head was rebuilt 10000kms ago.
Will supply a new Copper head gasket/Deco plate and sealer.
$1000 ONO
Cheers Ryan
Thread Starter
http://www.hyundaiaftermarket.org/images/vendor1.png
Joined: Jul 2008
Posts: 211
Likes: 0
From: Brisbane, Australia
Vehicle: 2003 Hyundai Accent 22PSI Boost
<div class='quotetop'>QUOTE (Stocker @ Sep 25 2010, 02:53 PM) <{POST_SNAPBACK}></div><div class='quotemain'>. . . not interested, but . . .
Who did the work, and do you have documentation?
Decked how much? Ported how, polished to what extent?
Not even one picture?</div>
not 100% sure who did the original work but know it was done in sydney, as for the full rebuild I had it done through hm gem in brisbane, friends with one of the blokes who has since died. Basically when the head was getting thermo cleaned it has stampings in the head near the water temp sensor as to when it was done. It is majorly ported oversized but was done for maximum efficentcy (i know wrong spelling). Decked 0.015". No pics as i havnt pulled the old motor apart but its a head. unless you know exactly what your lookign for they all look the same.
Cheers
Who did the work, and do you have documentation?
Decked how much? Ported how, polished to what extent?
Not even one picture?</div>
not 100% sure who did the original work but know it was done in sydney, as for the full rebuild I had it done through hm gem in brisbane, friends with one of the blokes who has since died. Basically when the head was getting thermo cleaned it has stampings in the head near the water temp sensor as to when it was done. It is majorly ported oversized but was done for maximum efficentcy (i know wrong spelling). Decked 0.015". No pics as i havnt pulled the old motor apart but its a head. unless you know exactly what your lookign for they all look the same.
Cheers
