I am going to be getting a new welder here soon hopefully and was considering starting to do some catback exhausts. I know I will do some locally and it wouldnt be to hard for me to make Tiburon ones and ship them out. They would be welded mandrel bends. I could probably do under axle or over axle. Im not sure what I would do for mufflers. Maybe have an option of a nice Magnaflow single inlet and outlet or maybe an N1 style can? Stainless Steel or Mild. I would do mostly 2.25 but could do bigger as well as needed.

Would there be any interest in this? Im not sure what pricing would be like. It all depends on what I can get the piping for. And these would be mostly made when an order is placed so there would be a wait period but I will keep it as low as possible. I may even keep a couple in stock possibly.

Basically just seeing if there would be interest and what you would be looking to pay with gaskets and hardware.

 

Mucho interest, dependant on price of course.

I've got some places you can buy nice prebent mandrel bends from, PM me.

And answer my last PM.

 

You offer a nice price and build it to spec and I'd be very interested. In fact, I'd take the ferry over from Muskegon and pick it up from you in WI. tongue.gif

 

i need an exaust now that ive got headers. would it be possible to get just from the cat to muffler inlet made for a smaller price, i could weld on a different muffler?

 

Same here, I already have a muffler I like. I am very interested pending price.

 

Yes I could easily do the center piece that would go to any axle back. Redz, Ill PM you now.

 

i say ya.. make a couple see what sounds good and make like 10 of them. id buy one depending on price, duh.

 

you could easily do an axle-back. with or without a muffler. would be relatively cheap and easy to ship. would be strictly for looks/sound though.

 

i would be interested depending on price. i would just need piping from cat to muffler.

 

I would be most interested depning on price/specs.