Fs - Oz-flow Bbtb
#1
Senior Member
Thread Starter
Join Date: May 2004
Location: Moncton, New Brunswick
Posts: 761
Likes: 0
Received 0 Likes
on
0 Posts
$200 US Shipped - In North America
I only had it on my car for a couple days. You can't buy these anywhere else.
Looking to sell my Oz - Flow BBTB,
For you guys that don't know what a OZ - Flow BBTB is it a custom made BBTB by a member on here Col. I'm not sure about the size but all the information is found here ---> ClickerClickCkickerson
Please Don't Spew your garbage of off postiness here tongue.gif
I only had it on my car for a couple days. You can't buy these anywhere else.
Looking to sell my Oz - Flow BBTB,
For you guys that don't know what a OZ - Flow BBTB is it a custom made BBTB by a member on here Col. I'm not sure about the size but all the information is found here ---> ClickerClickCkickerson
Please Don't Spew your garbage of off postiness here tongue.gif
#3
Senior Member
Thread Starter
Join Date: May 2004
Location: Moncton, New Brunswick
Posts: 761
Likes: 0
Received 0 Likes
on
0 Posts
You use your stock pulley so i don't know for sure. You would have to PM Col. It might be located in that post somewhere, i'll find out and get back to you.
#5
Senior Member
Join Date: Jul 2001
Location: Clovis, NM
Posts: 7,063
Likes: 0
Received 0 Likes
on
0 Posts
Vehicle: 2010 Jeep Wrangler Unlimited
Should be 62mm. I have the prototype and it is 60mm. You will need to remove your stock pulley and put it on this. The bar is not long enough to accomodate the cruise pulley.