Fs: Modded 2.0 Connecting Rods
Thread Starter
http://www.hyundaiaftermarket.org/images/vendor1.png
Joined: May 2002
Posts: 1,500
Likes: 0
From: Canada
Vehicle: x3 accent gk tiburon santa fe
those are out of my previous engine,
1 year old, bought them new from the dealer so they don't have 60 000 miles on them, they have around 6000 miles max of use
Beams have been polished to reduce weight and to remove stress riser
once that was done rods were shootpeened and blasted
final stage was balancing them in 3 different ways
all bigs ends are balanced to the same weight
all small ends are balanced to the same weight
all rods have the same total weight
those you allready did it or have it done know how long it takes to do it
price would be 200$ for the set of 4
i could add ARP bolts for the cost of the bolt and rehoning the big end and i'd redo the balance work to make them perfect again
i'll try to put picture later this week
1 year old, bought them new from the dealer so they don't have 60 000 miles on them, they have around 6000 miles max of use
Beams have been polished to reduce weight and to remove stress riser
once that was done rods were shootpeened and blasted
final stage was balancing them in 3 different ways
all bigs ends are balanced to the same weight
all small ends are balanced to the same weight
all rods have the same total weight
those you allready did it or have it done know how long it takes to do it
price would be 200$ for the set of 4
i could add ARP bolts for the cost of the bolt and rehoning the big end and i'd redo the balance work to make them perfect again
i'll try to put picture later this week
