12" Subs, Ported Box, Rockford Fosgate 300w Mono
01-19-2006, 10:56 PM
#1
Senior Member
Thread Starter
Join Date: Mar 2005
Location: Chillicothe, OH
Posts: 177
Likes: 0
Received 0 Likes
on
0 Posts
Well my system is still up for sale!
I was asking $400...but I dropped it down to $300 + shipping OBO...I need the money for my senior trip that will be coming up! The system retails at $500! Ohh and this system has hardly been used!!! I really dont do much bumpin with it seeing how my girlfriend complains about it hurting her head, so I usually have the amp & subwoofers off, so the system is practically brand new!
here's the info:
I have 2 American Bass 12s in a Ported box, and a Rockford Fosgate 300W at 2 Ohms Bridged mono Amp for sale...
American Bass 12's
http://i10.photobucket.com/albums/a1...0905/myamp.jpg
Ultra Thick Chrome-Plated Deep Bottom Basket.
NT Multilayer Foam Surround for Better Stable Linear Exclusion.
Stiff and Rigid non-press Paper Cone.
Inverted Dust Cap further increases Cone's resistance to flex under Pressure
Dual Black Mirror Tinsel Lead Wires.
Sleeved High Power Tinsel Lead Wires to resist Lead breakage.
Blackened Motor Parts for Superior Heat Dissipation & Long Life
Hi-Temp Anodized Aluminium Voice Coil Bobbin with Nonex Protection.
Ultra-Length Voice Coil for High excursion without Distortion.
Hyper extended Pole Piece Increases Accuracy, raises Induction.
Special Cooling Vents of Deep Bumped Back Plate to Increase Power Handling.
Uni-Rubber Gasket for Airtight Seal in Mounting.
Rubber Magnet Boot Protects Magnet.
Single Voice Coil 4 OHM
Retail Value : $120 each speaker
Rockford Fosgate 150 Watt Amplifier with Wired Remote Punch Bass Control
http://i10.photobucket.com/albums/a1...mericanB12.jpg
150 watts RMS power x 1 at 4 ohms
300 watts x 1 bridged RMS power at 2 ohms
CEA compliant
Variable 40-400 Hz low-pass or high-pass crossover
12 dB/Octave Butterworth crossover alignment
Variable 0 - 18 dB Punch Bass EQ at 45 Hz
Removable chrome sound
4 gauge power and ground connections
Built-in ATC fusing
Preamp outputs
Illuminated RF logo with output level display
Wired remote Punch bass control
TRANS-ana (TRANSconductance Active Nodal Amplifier) design simplifies the input circuit path for transparent and uncolored sonic performance
MEHSA (Maximum Efficiency HeatSink Application) yields up to 5 times better heat transfer from the Mosfet devices to the heatsink
Focused Mass heatsink places critical aluminum material where it's needed the most to keep the amplifier cool for increased efficiency and reduced distortion
Variable Voltage Power Supply Optimization "loosely" regulates the power supply circuitry for maximum output power at any given battery voltage
Custom designed TO-247 output Mosfets have 60% more metal tab area for improved thermal stability and wider linearity
Military Specification (Mil Spec) Glass Epoxy circuit boards accept larger copper traces for better current flow and resist vibration much better than inferior fiberglass circuit boards
Retail Value : $200
Box Retail Value: $100
I was asking $400...but I dropped it down to $300 + shipping OBO...I need the money for my senior trip that will be coming up! The system retails at $500! Ohh and this system has hardly been used!!! I really dont do much bumpin with it seeing how my girlfriend complains about it hurting her head, so I usually have the amp & subwoofers off, so the system is practically brand new!
here's the info:
I have 2 American Bass 12s in a Ported box, and a Rockford Fosgate 300W at 2 Ohms Bridged mono Amp for sale...
American Bass 12's
http://i10.photobucket.com/albums/a1...0905/myamp.jpg
Ultra Thick Chrome-Plated Deep Bottom Basket.
NT Multilayer Foam Surround for Better Stable Linear Exclusion.
Stiff and Rigid non-press Paper Cone.
Inverted Dust Cap further increases Cone's resistance to flex under Pressure
Dual Black Mirror Tinsel Lead Wires.
Sleeved High Power Tinsel Lead Wires to resist Lead breakage.
Blackened Motor Parts for Superior Heat Dissipation & Long Life
Hi-Temp Anodized Aluminium Voice Coil Bobbin with Nonex Protection.
Ultra-Length Voice Coil for High excursion without Distortion.
Hyper extended Pole Piece Increases Accuracy, raises Induction.
Special Cooling Vents of Deep Bumped Back Plate to Increase Power Handling.
Uni-Rubber Gasket for Airtight Seal in Mounting.
Rubber Magnet Boot Protects Magnet.
Single Voice Coil 4 OHM
Retail Value : $120 each speaker
Rockford Fosgate 150 Watt Amplifier with Wired Remote Punch Bass Control
http://i10.photobucket.com/albums/a1...mericanB12.jpg
150 watts RMS power x 1 at 4 ohms
300 watts x 1 bridged RMS power at 2 ohms
CEA compliant
Variable 40-400 Hz low-pass or high-pass crossover
12 dB/Octave Butterworth crossover alignment
Variable 0 - 18 dB Punch Bass EQ at 45 Hz
Removable chrome sound
4 gauge power and ground connections
Built-in ATC fusing
Preamp outputs
Illuminated RF logo with output level display
Wired remote Punch bass control
TRANS-ana (TRANSconductance Active Nodal Amplifier) design simplifies the input circuit path for transparent and uncolored sonic performance
MEHSA (Maximum Efficiency HeatSink Application) yields up to 5 times better heat transfer from the Mosfet devices to the heatsink
Focused Mass heatsink places critical aluminum material where it's needed the most to keep the amplifier cool for increased efficiency and reduced distortion
Variable Voltage Power Supply Optimization "loosely" regulates the power supply circuitry for maximum output power at any given battery voltage
Custom designed TO-247 output Mosfets have 60% more metal tab area for improved thermal stability and wider linearity
Military Specification (Mil Spec) Glass Epoxy circuit boards accept larger copper traces for better current flow and resist vibration much better than inferior fiberglass circuit boards
Retail Value : $200
Box Retail Value: $100
01-22-2006, 05:06 PM
#3
Senior Member
Thread Starter
Join Date: Mar 2005
Location: Chillicothe, OH
Posts: 177
Likes: 0
Received 0 Likes
on
0 Posts
http://i10.photobucket.com/albums/a122/cdu.../Picture006.jpg
http://i10.photobucket.com/albums/a122/cdu.../Picture010.jpg
http://i10.photobucket.com/albums/a122/cdu.../Picture008.jpg
http://i10.photobucket.com/albums/a122/cdu.../Picture007.jpg
http://i10.photobucket.com/albums/a122/cdu.../Picture013.jpg
http://i10.photobucket.com/albums/a122/cdu.../Picture010.jpg
http://i10.photobucket.com/albums/a122/cdu.../Picture008.jpg
http://i10.photobucket.com/albums/a122/cdu.../Picture007.jpg
http://i10.photobucket.com/albums/a122/cdu.../Picture013.jpg
01-24-2006, 06:21 PM
#5
Senior Member
Join Date: Jan 2005
Location: Edmond, Oklahoma
Posts: 152
Likes: 0
Received 0 Likes
on
0 Posts
one of my friends has an aultima that was looking to get some subs but is worried about getting used stuff. i will try and show him this stuff as soon as i can and let you know what he thinks