Hey,

keep an eye out for our sway bar we are going to make in a few weeks. I promise it will be the best sway bar available for the tib

Thanks,

Kevin
KJB Motorsports

 

Bar or Bars?

BTW< any comment on a package deal for the endlinks?

 

Hey,

We are concentrating on the rear sway bar for now. Its very possible to have a front one as well.

As far at the endlinks go. I think if we can get at least 10 people for a GB I can sell both for $150. Let me know who is interested.

Thanks,

Kevin
KJB Motorsports

 

I just purchased the rears this morning. Mine are shot! 02.gif

 

Id be in on a gb. Keep us posted on developing the bars

 

10?

Might be tight, but I'd be in for it.

So that's 2 sets right there.

 

sooner the better for me if that's a possibility. im working so much now that i have a pretty good deal of cash in the bank, but i don't know what it's going to be like once the semester starts back up.

 

Bar Bar Bar!

what diameter are you thinking of? 24? 26 mm?

 

Hey,

well, the choice is between 23mm and 26mm. We were leaning towards 23mm because we didn't want the car to have too much oversteer to the point where it would become hard to drive. Although custom bar can be made if you prefer a bigger bar than 23mm.

Thanks,

Kevin
KJB Motorsports

 

...Unless you'll release a beefier front one as well.... if only rear is in your plans, than you are correct.
I think that we'll be ok with 24..


How about the needed bushings to support the new diameter?.