Jsar Introduction As Request
#3
Senior Member
Join Date: Feb 2009
Location: Boston
Posts: 1,932
Likes: 0
Received 0 Likes
on
0 Posts
Vehicle: 2006 Pontiac GTO
It only takes a few minutes to write a proper intro, we all did it, and it's not such a bad idea to know a little bit about each new member
#5
Senior Member
Join Date: Mar 2002
Location: Los Lunas, New Mexico, USA.
Posts: 34,642
Likes: 0
Received 0 Likes
on
0 Posts
Vehicle: 2001 Hyundai Tiburon, 2004 Kia Sorento, 2010 Kia Soul
I pm'ed him and told him to do an intro like the others in this section using our outline.
Guess he don't read good. LOL
48 hours and counting... LOL
Guess he don't read good. LOL
48 hours and counting... LOL
#6
Senior Member
Join Date: Sep 2009
Location: Northwest Arkansas, cue the banjos.
Posts: 267
Likes: 0
Received 1 Like
on
1 Post
Vehicle: 2001 Tiburon 5spd
jsar, I know, I hated writing my intro and I thought it was stupid. But once you get to know the guys here on the forums you see why they do it. This is an awesome community, please write up an intro.
#7
Member
Thread Starter
Join Date: Dec 2008
Posts: 31
Likes: 0
Received 0 Likes
on
0 Posts
Vehicle: 2006/hyundai/tiburon
Ok, you guys are really a pain in my ass.................hehehe! Ok here goes....
Hi, my name is James or Jsar my nick here and NewTiburon.com.
I'm from Singapore.
I drive a Made in KOREA 2006 Hyundai Tuscani / Tiburon 2.0L BetaII CVVT.
I found these forums through NewTiburon.com
I've done the following mods to my car.
* Original Garrett GT3071R (T3, .63AR)
* Custom Stainless Steel Tubular Manifold & intercooler pipings
* Tial 38mm wastegate
* TurboXS RBV-H34 BOV
* Unichip Q plus boosting 2.2bar on VP Q16 race fuel
* AEM progressive methanol injection kit
* RD 1.8L pistons & rods set to bring down CR to 7.8:1
* Dual fuel rail - 4 x 580cc evo injectors + 4 x stock injectors
* Port and Polished head
* ARP head studs
* Kspec performance dual springs
* ECU reflashed for rev cut removal done by the koreans during one of their promotional tour in Singapore
* Flex-a-lite fans 210B 2 x 12" puller + 2 x 12" pusher billion fans
* SFR performance radiator + Redline supercool waterwetter + Pivot 1.3bar radiator cap
* SFR performance intercooler
* Custom 3" Stainless Steel full exhaust system with 2 x 2.5" catbacks
* QTP 3" electrical dump valve
* Transmission modified to Elantra 3.65 final drive
* SFR short shifter with custom gear knob
* Valeo extreme clutch (Now hunting for a 600ft/lb clutch kit or do a push style conversion and use EVO twin clutch)
* Kazz LSD
* Custom 4 points brace
* Custom front and centre strut bar
* Progress 22mm rear swaybar
* Drift racing coilover
* K-sport 8pots BBK and steel braided hoses
* Works emotion CR kai 17" bronze rims
* Defi link display with oil temp, oil press, fuel press, water temp, EGT
* Apexi AVCR boost controller
* Flatshift module
It's good to meet you all and I hope to learn from you
Hi, my name is James or Jsar my nick here and NewTiburon.com.
I'm from Singapore.
I drive a Made in KOREA 2006 Hyundai Tuscani / Tiburon 2.0L BetaII CVVT.
I found these forums through NewTiburon.com
I've done the following mods to my car.
* Original Garrett GT3071R (T3, .63AR)
* Custom Stainless Steel Tubular Manifold & intercooler pipings
* Tial 38mm wastegate
* TurboXS RBV-H34 BOV
* Unichip Q plus boosting 2.2bar on VP Q16 race fuel
* AEM progressive methanol injection kit
* RD 1.8L pistons & rods set to bring down CR to 7.8:1
* Dual fuel rail - 4 x 580cc evo injectors + 4 x stock injectors
* Port and Polished head
* ARP head studs
* Kspec performance dual springs
* ECU reflashed for rev cut removal done by the koreans during one of their promotional tour in Singapore
* Flex-a-lite fans 210B 2 x 12" puller + 2 x 12" pusher billion fans
* SFR performance radiator + Redline supercool waterwetter + Pivot 1.3bar radiator cap
* SFR performance intercooler
* Custom 3" Stainless Steel full exhaust system with 2 x 2.5" catbacks
* QTP 3" electrical dump valve
* Transmission modified to Elantra 3.65 final drive
* SFR short shifter with custom gear knob
* Valeo extreme clutch (Now hunting for a 600ft/lb clutch kit or do a push style conversion and use EVO twin clutch)
* Kazz LSD
* Custom 4 points brace
* Custom front and centre strut bar
* Progress 22mm rear swaybar
* Drift racing coilover
* K-sport 8pots BBK and steel braided hoses
* Works emotion CR kai 17" bronze rims
* Defi link display with oil temp, oil press, fuel press, water temp, EGT
* Apexi AVCR boost controller
* Flatshift module
It's good to meet you all and I hope to learn from you
#9
Member
Thread Starter
Join Date: Dec 2008
Posts: 31
Likes: 0
Received 0 Likes
on
0 Posts
Vehicle: 2006/hyundai/tiburon
<div class='quotetop'>QUOTE (radu_rd2 @ Jun 3 2009, 12:36 PM) <{POST_SNAPBACK}></div><div class='quotemain'>Your car sounds sick!! Welcome!</div>
Not at all...............its a daily driven 606bhp hyundai :-)
Not at all...............its a daily driven 606bhp hyundai :-)