Does anyone make pods for the 01 tib? Not the universal sh*t, something made for the 01 tiburon. I did see someone that used the air vents as pods....how would that work?

 

No.


and the vent gauges require custom mounting, PM tibminn

 

There is a pillar pod that was made for us. Speaking of which I need one... Wonder if anyone is still selling them?

 

^I have that one and even though it was "made" for us..there was still a little trouble getting it on.

 

Where did you get it and do you have a pic?

 

thats because to get it on you are really supposed to take off all the trim behind the pillar panel.

 

^That wasnt the problem. alex had to force it to fit into the holes for the clips, it didnt seem to have the same curvature, the trim wasnt in the way




I got it from a user here on RD. Unfortunately I dont have a picture of it on my laptop.

 

Please dont quote the post above yours. It's a forum rule.

 

I got the first group buy of triple pod full replacement pillars. It had problems too. You slide it down into the dash, but have to make holes halfway up to screw in a bracket. It doesnt line up correctly either. I think it's because they copied the stock one while it's out of the car, and the stock one bends into shape to fit the holes, but you can't bend fiberglass like that. So it doesn't shape the same as the stocker when putting it in the car.

Before I got it, I had created a panel that covered the inside of the glovebox out of ABS plastic. It looked professional and fit perfectly. I had 3 gauges in there. The only problem with that setup is having to look across the car.

 

This was the one...



I just needed a single pod for my boost guage, so i sold it to her