welp i searched around and didnt find a DIY on it and was wondering how everyone has theres setup

dis2 on beta motor

thanks

 

Hmm...I looked through the installation manual and one of their configurations was basically exactly the way to do it on an Alpha or Beta. Don't think I've seen a DIY though.

 

The DIY I used liked 4 years ago came from ElantraXD.com

 

the on on exd doesnt have pics anymore...

take me some pics of yours jon and i can figure it out from there

 

I have a DIS 4, so it'll be a little different. At one point, I wanted to feed 4 coils individually.

 

I had 4 individual MSD Blaster SS coils being run off a DIS2. The Tiburon has a wasted spark system, so even with 4 coils, there's still only two channels (hence the reason for only 2 coils from the factory). I'll see if I can find my write-up. I originally posted it on HP.com if you feel like searching. Pic of my setup:



WQTIO08.jpg



WGFgJby.jpg

 

I didn't want to run wasted spark. You can't do that with a dis2.



I'll still try to get pics but I've been sick since Tuesday.

 

its ok man its not like its a hurry now...

 

See pic above. DIS 2 (not 4) running 4 coils in a wasted spark configuration. I split the trigger wires. One trigger wire fires coils 1 and 4 the other fires coils 2 and 3.

From my HP.com post:

"I have them, but my wiring is going to be different from yours ('01 Tib). Because of this, I can't give you wire colors. However, I can tell you that you want to attach the trigger wire (-) from your 1-4 coil to the MSD's channel 1 input wire (white) and the trigger wire (-) from your 2-3 coil to the MSD's channel 2 input wire (green). Attach the positive (+) wire from your original coils to the MSD's thin positive wires (red). You'll then need to split the MSD's channel 1 (-) output wire (brown/white) and attach the two wires to the negative posts of your new coil #1 and coil #4 and split the MSD's channel 2 (-) output wire (brown/green) and attach the two wires to the negative posts of your new coil #2 and coil #3. You then need to attach the MSD's positive (+) output wires (brown/orange) to the new coil's positive terminals. Then hook up the thick red and black wires to power and ground.

http://www.msdignition.com/pdf/dis2_dis4.pdf

There's a diagram at that link.... page 11. The only difference is that you need to split the wires to 4 coils instead of to one coil, like in the diagram."

 

You didn't understand me. I didn't say you could not use 4 coils on a DIS 2. I am saying you cannot run 4 coils, fired individually as a non-wasted spark system, on a DIS 2. That is because it only has 2 channels. A DIS 4 has 4 channels. I was not going to use a wasted spark system. I was going to individually fire 4 coils. Your 4 coil setup, with wasted spark, is dividing the energy between the 2 coils, therefore not optimizing the coils potential output. It's getting "half" power. And even less in wasted spark firing.