Hello fello Hyundai owners, I picked up a N2MB 2 step with out the flat or so called wot shifting feature. The only thing is that they dont have actual instructions on how to install this piece of gear on the Hyundai Tiburon. They give you a basic set of instruction. Yet there are a few wires mainly the igntion wires that tie into the wot box and i dont know which one goes where. Does anyone have one, and if so can you send me some pics of your install! Owe and this is going on a 99 Tibby!

 

Well, I just looked over the universal installation instructions here.

Seems straightforward enough.

Pin 1 Yellow - RPM Connect to Fuel Injector Drive Signal or Ignition Control Signal (varies by car model)
Pin 2 Black - Ground Connect to chassis ground
Pin 3 Black - Power Out Connect to ignition coil power wire going towards the ignition coils.
Pin 4 Blue - APP Connect to Accelerator Pedal Position Sensor or TPS (varies by car model)
Pin 5 Green - Clutch Connect to Clutch Pedal Position Switch
Pin 6 Red - Power In Connect to ignition coil power wire going away from the ignition coils.

My interpretation:

Pin 1 Yellow - Connect to one of the coil pack's incoming signal wires
Pin 2 Black - Ground Connect to chassis ground
Pin 4 Blue - APP Connect to TPS sensor output wire
Pin 5 Green - Connect to Clutch Pedal Position Switch for cruise control cancel

For this bit, cut the positive wire headed to the same coil pack that you tapped into for Pin 1. Your WOT box will basically become a component inline with this wire.
Pin 3 Black - Power Out Connect to ignition coil power wire going towards the ignition coils.
Pin 6 Red - Power In Connect to ignition coil power wire going away from the ignition coils. (back towards ECU)