Few new pics of my LC/ blue intake
03-02-2003, 07:11 AM
#1
Senior Member
Thread Starter
Join Date: May 2001
Posts: 466
Likes: 0
Received 0 Likes
on
0 Posts
Few new pics of my LC/ blue intake
Snow finally melted so i got my *** out and got some better pics. I also added pictures of my new blue intake.
As you can see fog light holes are much larger then usuall , that's bc i cut tehm out too big when instaling foglights. I ended up putting mesh behind them so it looks little better
Yamaneko,if you will please use these pics instead of the old ones for SR site.
[ March 02, 2003, 02:20 PM: Message edited by: Big_Al ]
As you can see fog light holes are much larger then usuall , that's bc i cut tehm out too big when instaling foglights. I ended up putting mesh behind them so it looks little better
Yamaneko,if you will please use these pics instead of the old ones for SR site.
[ March 02, 2003, 02:20 PM: Message edited by: Big_Al ]
03-02-2003, 08:14 AM
#5
Senior Member
Thread Starter
Join Date: May 2001
Posts: 466
Likes: 0
Received 0 Likes
on
0 Posts
It's an eclipse intake
heres what i used:
http://cgi.ebay.com/ebaymotors/ws/eBayISAP...2403410263&rd=1
at fist i was going to do some sliceing and diceing,but then this ended up a better fit.
heres what i used:
http://cgi.ebay.com/ebaymotors/ws/eBayISAP...2403410263&rd=1
at fist i was going to do some sliceing and diceing,but then this ended up a better fit.
03-02-2003, 10:55 AM
#7
Senior Member
Join Date: Nov 2002
Posts: 182
Likes: 0
Received 0 Likes
on
0 Posts
did you just put the side of piping that,in the picture the cone filter is.
did u have to do anything else to put it in. or did u just take the small piece of the intake off and bolt it right on.
detail would be appreciated.
Drew
where did u get that strut and for how much?
[ March 02, 2003, 05:56 PM: Message edited by: PrOjEcT BLuE 02 ]
did u have to do anything else to put it in. or did u just take the small piece of the intake off and bolt it right on.
detail would be appreciated.
Drew
where did u get that strut and for how much?
[ March 02, 2003, 05:56 PM: Message edited by: PrOjEcT BLuE 02 ]
