Fender Flares
Thread Starter
Administrator
Joined: May 2001
Posts: 23,226
Likes: 9
From: Upstate NY
Vehicle: 2010 Genesis 2.0T
Fender Flares
So I've made the decision to mold in some low profile fender flares on the tib over the winter. I dont want those obnoxious looking ones that stick way out, or hang alot lower than the fender. Just something light and subtle.
I'm thinking something like these:
These would be PERFECT:
Or even these too...
So, does anyone know where I might be able to get any of these?
I'm thinking something like these:
These would be PERFECT:
Or even these too...
So, does anyone know where I might be able to get any of these?
Super Moderator
Joined: Mar 2006
Posts: 1,304
Likes: 0
From: ABQ, NM
Vehicle: 2001 hyundai tiburon
not bad. i searched and searched for some flares when i had my tib. never finished the body work before i sold the car though.
i tried looking for plastic ones, but the measurements were not close enough on any i could find.
i tried looking for plastic ones, but the measurements were not close enough on any i could find.
Super Moderator
Joined: Mar 2006
Posts: 1,304
Likes: 0
From: ABQ, NM
Vehicle: 2001 hyundai tiburon
they were some cheap ones off ebay made from FG.. i just molded em in... mostly. HAHAHA.
they LOOKED like they were cast from a 00-04 mustang.
ill try to find them. i had to do alot of trimming on the flares, but the ID/radius was un touched on the front for the most part.
the rear flares are pretty much non existant in those pics.
closest i can find to what i had flareZ
they LOOKED like they were cast from a 00-04 mustang.
ill try to find them. i had to do alot of trimming on the flares, but the ID/radius was un touched on the front for the most part.
the rear flares are pretty much non existant in those pics.
closest i can find to what i had flareZ