Where is everyone getting the so called HKS rear-section exhaust? And is this the muffler and some piping that ends in a flange or is this the muffler only.
And one last thing how much has anyone paid for it

Thanks
JD

 

I got my through MHP and it bolts to same place as the factory one. It uses the factory hangers and everything but watch out b/c it may fall over to the left and rest against the bumper. This happened on mine but was fixed when I did the cat back piping. I think I paid $300 or so for it. But it's been awhile so I'm not real sure.

 

Anyone else have this or know where to get it. MHP's website doesn't have it on there.

Thanks

 

any local rice shop that carries hks products can order you the axel back for your car

 

Haha, I got mine here. http://www.alamomotorsports.com/hksex.htm
Although I got it when HKS was having a special, so it was for $260. Now it's like $325, ouch. All in all though, it got here in 2 weeks. Not bad. You should call em up for availability just in case. I ordered that exhaust like 2 yrs. ago.
-Dyson

 

Oh might I add though. The muffler itself is not polished. Just the tip. So I say this, if you want full polished just go and find one you like and have it welded. It could actually be alot cheaper for you in the long run. But I do like my HKS muffler. After 2 yrs. still no rust, and has a nice throaty sound, very audible, but not LOUD. You gettin me? wink.gif
-Dyson

 

Sweet thanks...that site says it is only for gen1 but i assume they have them for gen2
Thanks again

 

Man! I didn't read your post fully. It's the rear section only. Without the middle cat-back pipe. It bolts right up, though. I jacked my car up, and took about 15 - 20 min. to install.
-Dyson