Custom Intake Pics
#1
Guest
Posts: n/a
Custom Intake Pics
It is made with 3" ABS pipe and rubber bends for the pipe. Anymore questions just ask.
http://albums.photopoint.com/j/View?u=1686...ence=0&res=high
http://albums.photopoint.com/j/View?u=1686...ence=0&res=high
http://albums.photopoint.com/j/View?u=1686...ence=0&res=high
These are pics while the installation was being done. All parts are back on in the original places.
http://albums.photopoint.com/j/View?u=1686...ence=0&res=high
http://albums.photopoint.com/j/View?u=1686...ence=0&res=high
http://albums.photopoint.com/j/View?u=1686...ence=0&res=high
These are pics while the installation was being done. All parts are back on in the original places.
#3
Guest
Posts: n/a
OK man read....
I used 3" ABS pipe and the rubber bends for it. I got it at Lowes, but you could use PVC if you wanted too. I just liked the black look better. The pipe comes in 10' sections so you will have lots left. I cut the hole at the bottom first and put the 90 degree elbow in and then measured and cut the piece going up. I then cut the top bend to where it fit the best without any closing. The filter is the same one that goes on all of the intakes you can buy. I cut a piece plastic tubing to go in side of the filter rubber to keep it from crushing. The filter sits inside of the 90 degree elbow and is clamped on the outside.
I used 3" ABS pipe and the rubber bends for it. I got it at Lowes, but you could use PVC if you wanted too. I just liked the black look better. The pipe comes in 10' sections so you will have lots left. I cut the hole at the bottom first and put the 90 degree elbow in and then measured and cut the piece going up. I then cut the top bend to where it fit the best without any closing. The filter is the same one that goes on all of the intakes you can buy. I cut a piece plastic tubing to go in side of the filter rubber to keep it from crushing. The filter sits inside of the 90 degree elbow and is clamped on the outside.