Eibach Pro - for the Elantra
Thread Starter
Senior Member
Joined: Apr 2002
Posts: 605
Likes: 0
Eibach Pro - for the Elantra
I'm not sure if you guys are already aware of this, but I was doing some research and found these Eibach Pro-kit Lowering Springs SPECIFICALLY made for the Elantra. The part number is 4218.140, right from Eibach's page
It states that these will lower the car 1" in both the front and back.
So my next question is if I get 215/40/17's on 17"x7" Motegi rims {as I plan}, will a 1 inch drop be too much? As it may not allow for proper clearance.
EDIT: does anybody know where one could find the MSRP of Eibach products? They don't even have a customer service e-mail address on their website.
[ January 02, 2003, 08:43 AM: Message edited by: ELANTRAVISION ]
It states that these will lower the car 1" in both the front and back.
So my next question is if I get 215/40/17's on 17"x7" Motegi rims {as I plan}, will a 1 inch drop be too much? As it may not allow for proper clearance.
EDIT: does anybody know where one could find the MSRP of Eibach products? They don't even have a customer service e-mail address on their website.
[ January 02, 2003, 08:43 AM: Message edited by: ELANTRAVISION ]