i just installed that Kspec Front strut Bar a few min ago end wanted your opinion on what i did with the knock or Accel Sensor i read that it should stay facing same direct so what i did is just trim the Braket a bit and voilĂ* tongue.gif

http://img376.imageshack.us/img376/7...rutbar57jd.jpg

http://img376.imageshack.us/img376/8...rutbar47sa.jpg

http://img376.imageshack.us/img376/273/strutbar33me.jpg

http://img376.imageshack.us/img376/5...rutbar22kn.jpg

you see here facing front of the car.... as it was olding by the bolt on the strut mount smile.gif

http://img376.imageshack.us/img376/1...rutbar16hq.jpg

you see a bit here where i trim the braket with a dremel wink1.gif


hope it's ok ? and it wont cause any problem

 

check diy section redz made a diy for the accel thing

but ya looks good fing02.gif

 

that was the same one i had, which got sold to Kit-Fox... looks good

take out your resonator though!! haha

 

Yeah, I didn't look, but if your resonators are there, you are missing out on some power.

 

there aren't there anymore tongue.gif and i notice the small power diffrence tongue.gif sound nice too with out i removed them afther reading the DIY tongue.gif just did a clean job i closed the hole afther tongue.gif

mb1604 i know i read the DIY but i just left the Sensor where it was originaly tongue.gif insted of fliping the sensor on the braket tongue.gif