Hyundai Aftermarket - 9/10/15 Photo Shoot

Hyundai Aftermarket (https://www.hyundaiaftermarket.org/forum/)

- Vehicle Showroom (https://www.hyundaiaftermarket.org/forum/vehicle-showroom-91/)

- - 9/10/15 Photo Shoot (https://www.hyundaiaftermarket.org/forum/vehicle-showroom-91/9-10-15-photo-shoot-31435/)

Niice! all around my man,

keep it up. I'm anxious to see what's next.

Not bad, have you ever considered getting a wing?

i considered it but i like the way it looks without it. plus i think the cops out here look for it. we do have allot of street racing and the cops dont hesitate to pull any1 over.

nice ride man, I like it with out the wing

Very Nice.. unlike the RD2 with their odd shaped trunks, the RD1s actually look good without a wing...

And as for your comment about street racing.. I certainly hope you are not into that. If you are, we do not want to hear about on the site...

i am not into it i was just stating that it was in this area big time and cops are cracking down on it. so i would not want a spoiler for this reason and that i like my car without it.
every1 always says to get a spoiler but i think it takes attention away from your car and more to that "thing on your car"
i was thinkin about getting the evo hood but im not sure if it would look good purple and cf hmm?

Lookin good man, engine bay looks a little dirty in a few of the pics, but still looks nice.

Looks good. That is a very nice purple, its a bit of black with tone of purple. btw, how were you able to relocate the canister, i cant seem to fit my canster where you place it.
What you do to make it fit?

u have to take off the houses and brackets and just have the canister up there. then run the houses from the bottom to the top and leave the houses off the canister where u found the canister at the bottom. just take the canister by itself to a parts store and ask for hosing to fit it 3 ft long make sure its fuel line then get two conectors fitting the smaller hoses (theres three hoses) . i had to bend the brackette on one to make it fit underneath (the one where the sensor goes into) used a left over screw and put that back on right next to the intake (theres three holes put it in the one next to your intake screw). ok so theres three hoses coming from up top the big on goes into the thing u just screwed on then were the two hoses came out of the wall u hook those up to the remaining hoses coming from the top.

well its hard to explain but if u want to ask anymore questions just ask but your not to far from me u could stop by and i could help u if u wish or i could come up there but gas sucks right now never been to frisco though would be nice.

just let me know