well here's the deal guys, i have a couple questions about nitrous that haven't been answered by the threads i've seen. First off, if i remember right, people have said that a 35 shot should go over without any mods to the engine. well, i'm thinking of running a 50 shot, but i was wondering what i'd have to do to my engine to make it withstand it. keep in mind that my engine has almost 80k miles on it and i live in california, AND i'm very paranoind about stuff like this, as my tib is my daily driver. so i was looking for suggestions on how to get my engine to withstand a 50 shot, while keeping it emissions legal, as i live in Cali.

also, as for actually using nitrous, i've noticed that you say don't use nitrous in 1st gear, as the added torque would probably tear the driveline to pieces. my question is, since nitrous is hooked to the switch which engages the WOT sensor, does this mean i have to take off in 1st, shift into 2nd, reach down, hit the switch and then floor it to have nitrous? any suggestions on how to do that or am i missing something? i think i have more nitrous questions, but i can't think of them offhand. but thanks in advance for the help!

Solo

moving to power adders.

I dont think you need something else to use 50shot of nitruos.

I have used a lot of time 50shot in my automatic tiburon and I have no problems.

You should be just fine with 50 shot! Got the clutch yet?

i sprayed in first gear, never had a problem. of course it was always toward the end of the rev. for instance, i would rev to 3200ish rpm, dump the clutch, 3/4 throttle until 5,500 rpm, then wot. then 2nd gear, and third.
the only problem i had was the pos spec clutch i had.

so all i need is colder plugs then? how about driving with nitrous? i posted up there about my concerns about driving it, but i also wanna know how long i should keep the nitrous going, what gear should i stop using it in, etc.

no more than 15 seconds MAX TOTAL use.

yes, colder plugs for 50 shot, nothing else. (clutch is good like OP said)