E6K update is here Cheauk was right
Thread Starter
Senior Member
Joined: Jul 2001
Posts: 158
Likes: 0
Senior Member
Joined: May 2001
Posts: 1,436
Likes: 0
The 3-wire bypass air control requires TWO PWM outputs?? Bah! Screw that, I'm gonna go buy either an RX7 idle solenoid or more likiely a GM 4-wire part instead.
No way in hell I'm soaking up TWO of my PWM outputs for a damned idle speed controller. wink
Good catch on the beta software, how did you pirate that? wink Obviously it's not an external release yet, is this the version that finally goes to the new Windows 3D interface?
No way in hell I'm soaking up TWO of my PWM outputs for a damned idle speed controller. wink
Good catch on the beta software, how did you pirate that? wink Obviously it's not an external release yet, is this the version that finally goes to the new Windows 3D interface?
Senior Member
Joined: Nov 2001
Posts: 394
Likes: 0
I don't think the windows thing will ever happen. Although I saw Matt with a continuously preproduction software.
The guys at Haltech are completely absorbed with the E11 to worry about anything else.
It is kind of funny how easy it is to use up all the PWM outputs. I LOVE the secondary rev limiter and the intercooler fan control.
The guys at Haltech are completely absorbed with the E11 to worry about anything else.
It is kind of funny how easy it is to use up all the PWM outputs. I LOVE the secondary rev limiter and the intercooler fan control.