hmmm.. interesting that it fits so tight against the back seat. I use my hatch with fair regularity, so putting the seats up and down is a weekly thing for me. I also have my fireextinguisher mounted to the backside of the driver's side rear seat..

It is pretty tight, but not too big of a nuisance.

So tibwrcsbj, you're saying the racetech bar is 6 sided?

Well, on mine it's so tight I can't close the back seats.

I think I'm gonna take it off, elongate the holes on the brackets, and push it back some.

Shouldn't be a problem when I put my back buckets in though...

Hrmm,.. the SR (CoughKINGSAFECough) bars that I have seen installed are tight, but you can still put the rear seats down and up without a problem

I have an old JUNTOS bar, looks like the SR one, but mine's chrome (shinny) and it's tighter than the SR ones. I think I'm the ONLY one that has an this one,( in North America anyway) and it's tight but the rear seats will go back up.

yeah. kaijai, it is six sided.

i'll do a test fit before i tighten the bolts, just to make sure i won't have the same prob as redz, it was enough of a b**** to get all that sh1t out to do my dynamat, i don't want to have to do it again after the strut bar is installed.

Well, i just installed it oday and i didn't have any probs with the rear seats. Yeah i had to kind of pull them fairly hard to get them to lock, and do definately hit the rear seats, but its right in the middle where the two seats meet, so if you pull on them from behind near the lock mechanism they arent very hard to get to lock.

Oops, just noticed the dbl post (does it still count if its on another page??)

KaiJai, I will email you a couple of pics sometime this week, if you still want them.

Exhaust Question (muffler swap and resonator addition)
 

Yeah, that be kewl.
Just never seen the RaceTech bar before. Would love to see what it looks like
Thanks
laugh.gif

Can you post any pics for us?

i can't post any pics from here (i do most of my posting from work)

KaiJai after you get them, can you post them?? and also maybe one or two to go into the "things you found out" topic for me, i've got pics of the 3rd gen cargo net in a second gen. I'll get the strut bar pics off to you either today or tomorrow.

Thanks

Ok, Sounds good.

Do it before the weekend, I'm off on a ski trip, so I won't be able to do anything for a week after.
laugh.gif

Ok, just got the pix:

http://www.members.shaw.ca/camt/kspecbar/DSC00363.JPG
http://www.members.shaw.ca/camt/kspecbar/DSC00364.JPG
http://www.members.shaw.ca/camt/kspecbar/DSC00365.JPG
Nice close ups of the HEX rear bar:
http://www.members.shaw.ca/camt/kspecbar/DSC00366.JPG
http://www.members.shaw.ca/camt/kspecbar/DSC00368.JPG
ANd How tight it is in the middle:
http://www.members.shaw.ca/camt/kspecbar/DSC00367.JPG
Good shot of the trunk:
http://www.members.shaw.ca/camt/kspecbar/DSC00369.JPG