AEM FIC wiring
#11
Senior Member
Join Date: Sep 2013
Location: Vancouver washington
Posts: 132
Likes: 0
Received 0 Likes
on
0 Posts
Vehicle: 99/ Hyundai /accent
Understand! What's confusing me now... Is that I can connect my base tune that was sent to me... But I tried to relash the fic and I can't because the z file is no where to be found!! Could it be because I don't have the cd that comes with the fic?
#12
Senior Member
Join Date: Mar 2009
Location: Red Deer
Posts: 829
Likes: 0
Received 0 Likes
on
0 Posts
Vehicle: 2012 mitsubishi eclipse spyder gs, 2001 hyundai tiburon
There should be a z file downloadable from the aem power website forum. Can't quite remember which sub-section, but, i'm pretty sure it's there.
#13
Senior Member
Join Date: Sep 2013
Location: Vancouver washington
Posts: 132
Likes: 0
Received 0 Likes
on
0 Posts
Vehicle: 99/ Hyundai /accent
So I used a friends lap top and did everything right... But the fic is still reading that I'm under boost with the car off and key in on position
#16
Super Moderator
If it reads pressure when you aren't boosting, double check your MAP sensor power/ground as well as the signal output, and check its wiring. Be sure you are feeding the computer good data, before suspecting the computer.